Why embroidery puckers, and how to stop it
Every stitch is a piece of thread under tension between two holes, and it pulls those holes toward each other. Thousands of stitches pull the cloth with them: that is what puckers a design and pulls it out of shape.
What you see when cloth moves
- Puckering: the cloth gathers around the design, worst around dense fills.
- Shapes shrink along their stitches: a filled circle sews as an oval.
- Gaps: an outline sewn after a fill no longer meets its edge, because the fill had already moved the cloth.
Hoop it firmly
Hoop the cloth and the stabilizer together, taut but not stretched. Cloth stretched in the hoop springs back when it comes out, and puckers everything sewn on it. Knits and T-shirts stretch most easily, so take the most care with them.
Use a stabilizer
- Cut-away for knits and stretchy cloth: T-shirts, polo shirts, fleece. It stays in and keeps supporting the stitches as the garment is worn and washed.
- Tear-away for firm woven cloth: canvas, denim, twill.
- A wash-away topping on towels and fleece, so stitches do not sink into the pile.
Allow for the cloth: pull compensation
Digitizing programs make each shape a little longer along its stitches, so that it sews at the size it was drawn. This is pull compensation. The converter here does it point by point: it works out how far the cloth moves under each needle point, from how much thread is sewn around it and when, and moves the needle to allow for it.
Tell it your cloth under Advanced settings → Cloth:
| Firm: canvas, denim, twill | allows for 1 % |
|---|---|
| Medium: cotton, poplin | allows for 2 % (the usual choice) |
| Stretchy: T-shirt, piqué, fleece | allows for 4 % |
The stitch preview shows where the thread ends up once the cloth has moved, so you can see the result before you sew.
Convert a picture with your cloth allowed for
Questions
What is pull compensation?
Making shapes slightly larger along their stitches, so that the cloth pulling in as they are sewn brings them back to the size they were drawn. Without it, fills shrink and outlines leave gaps.
Why does my outline not line up with the fill?
The fill was sewn first and pulled the cloth in, so the outline, sewn where it was drawn, misses the moved edge. Firm hooping and stabilizer reduce it; pull compensation corrects it.
Which stabilizer should I use for T-shirts?
Cut-away. T-shirt knit stretches, and cut-away stays in to support the stitches through wear and washing. Choose “Stretchy” as the cloth when you convert.
More guides
- Embroidery file formats explained: Which file your machine reads, and what each format keeps or leaves out.
- Choosing a picture for embroidery: What sews well, how many pixels you need, and how many colours to use.